The WPM-245 cuts corrugated plastic conduit from 4 mm to 25 mm outside diameter to a set length, automatically, straight off a coil. Length and batch are entered on a 7-inch true-colour touchscreen under PLC control, and the machine cuts 50 pieces per minute at a 200 mm length. It stands 1770 x 660 x 1550 mm at 270 kg, with the coil carrier built into the frame below the cutting head.
Corrugated tube is the hard case for a shear because the wall is thin and the profile is not round: a blade that closes too fast crushes the crest, and one that closes too slowly tears the slit. The tube is driven through the head on a belt so the pitch is advanced positively rather than pulled by the blade, and the cutting head is enclosed behind a guarded cover. A separate height-adjustable guide stand at the outlet carries the cut piece clear instead of letting it drop onto the stack.
It is a cutting machine and stops there. The WPM-100 cuts sleeve, tube and belt to length as a general-purpose cutter, and the WPM-1-6 and WPM-0.5-10MM2 strippers remove insulation or enamel rather than parting a tube. The 245 is the one built around coiled conduit, with the decoiler under the table and a feed that follows the corrugation instead of fighting it.
Key Features
1. Cutting range of 4-25 mm outside diameter accepts the common conduit sizes used in harness and panel work on one head.
2. 50 pieces per minute at a 200 mm cut length, driven by PLC with the count and length set on the panel.
3. 7-inch true-colour touchscreen carries length, quantity and speed, so a job change is a program edit rather than a mechanical setup.
4. The tube is advanced on a belt through the cutting head, which holds the pitch against the blade instead of letting the blade pull the coil.
5. The cutting head runs inside a guarded enclosure, keeping hands away from the blade during the 50 cuts per minute cycle.
6. A full coil is carried on the decoiler built into the frame below the table, and a height-adjustable outlet guide sets the discharge height to the container so long cut lengths do not bend as they leave the head.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-245 |
|---|
| Machine type | Automatic corrugated pipe cutting machine with integrated decoiler |
|---|
| Control panel | 7 inch true colour touchscreen |
|---|
| Control system | PLC |
|---|
| Power | 220 V 50/60 Hz |
|---|
| Cutting diameter | 4-25 mm |
|---|
| Output | 50 pcs/min at 200 mm cut length |
|---|
| Air pressure | 0.6-0.8 MPa |
|---|
| Size | 1770 x 660 x 1550 mm |
|---|
| Weight | 270 kg |
|---|
| Outlet guide | Height adjustable stand |
|---|
| Cutting head | Enclosed behind guard |
|---|
Applications
— Automotive wiring harness: corrugated sleeve cut to branch lengths of 200 mm and up for covering harness runs before taping.
— Control panel and switchgear building: slit conduit cut to fixed lengths for routing panel wire between ducts and doors.
— Appliance and HVAC assembly: corrugated tube cut to length for protecting refrigerant sensor and fan leads.
— Cable protection on machine tools: conduit cut in batches to cover exposed cable runs between the cabinet and the moving axis.
— Contract cutting services: coiled conduit converted to fixed-length kits, where the 50 pcs/min rate at 200 mm sets the batch cost.