JST Flag Terminal Crimping Mold for Horizontal & Vertical Crimping JW-AP20
JST Flag Terminal Crimping Mold for Horizontal & Vertical Crimping JW-AP20 Thumb
Video Thumbnail

JST Flag Terminal Crimping Mold for Horizontal & Vertical Crimping JW-AP20

📅 2023-01-06 👁️ 1,938
  • Model No: JW-AP20

  • Specifications

    Compatible Terminals: JST flag terminals
    Crimping Types: Horizontal and vertical crimping
    Compatibility: OTP U-shaped molds
    Application: Terminal machine applicator dies
    Use Case: Industrial cable harness manufacturing
  • Inquiry now

JW-AP20 is a JST flag terminal crimping mold for terminal machine applicators, with horizontal and vertical crimping. The die is built in the OTP U-shaped format and is compatible with OTP U-shaped mold sets.

The front block is relieved to open a throat wide enough for a flag body, so the terminal sits sideways in the die and the barrel, not the flag, is presented to the punch. The base is extended to carry the wider terminal without overhang, which keeps crimp height even across the flag width. This is the difference that separates it from a straight die: a straight die cannot close on a flag terminal because the flag body fouls the front block.

It is used where a harness includes flag terminals that cannot be run on a straight die, and it replaces the flag die in existing JST applicator frames. Because the die is specific to the flag form, a build carrying both straight and flag terminals needs two dies but can share one applicator.

Key Features

1. Flag terminal die form with a relieved front throat for right-angle terminal bodies

2. OTP U-shaped die profile, compatible with OTP U-shaped mold sets

3. Horizontal and vertical crimping of flag terminals

4. Extended base that supports the wider flag footprint and keeps crimp height even

5. JST terminal applicator mounting as an applicator die

6. Terminal-specific die change inside an existing applicator frame

Technical Specifications

ParameterSpecification
ModelJW-AP20
Compatible terminalsJST flag terminals
Mold formFlag terminal die, OTP U-shaped
Crimp orientationHorizontal and vertical
MountingTerminal machine applicator die
Use caseIndustrial cable harness manufacturing

Applications

— JST applicator presses crimping flag terminals, where the wire leaves the barrel at a right angle to the terminal axis

— Harness builds that carry both straight and flag terminals and switch dies on one applicator frame

— Panel and equipment wiring, where flag terminals are used at right-angle connections

— Replacement of a worn flag die on an existing JST applicator without a frame change

— Automotive sub-assemblies where flag terminals are crimped close to a connector body

JST flag terminal crimping mold at bottom, with horizontal and straight molds above
JST Flag Terminal Crimping Mold

Send us your question about this product

No file chosen
JPG / PNG / WebP, up to 10 MB each