The WPM-81ML coils, heat-cuts and binds 4 mm wire in one cycle. Lengths run 1.5-5 m, the coil is closed with a figure-8 single tie that brings head and tail out on the same side, and the tie diameter stays within 40 mm. Rated output is 800 pcs/h at 1.8 m.
On a 4 mm jacket a mechanical blade leaves a cut edge that opens up and drops strands into the coil, and both ends then have to be trimmed again before packing. This machine separates the wire thermally and binds in the same cycle, so the lead leaves with both ends finished and positioned. Head and tail of 130-150 mm come out on the same side, so the bundle can be bagged or hooked without turning it.
The 81ML is the short-length, thick-jacket unit here: 4 mm wire over 1.5-5 m, against the 3-25 m and 3-40 m ranges of the other coilers. It holds longer ends at 130-150 mm, ties figure-8 with both ends on the same side, and cuts thermally rather than with a blade. At 2800 W and about 230 kg it is a standalone bench-scale machine, not a line unit.
Key Features
1. Coil, heat cut and bind closed in one cycle on 4 mm wire, without an intermediate handling step.
2. Thermal cutting instead of a blade: the jacket is separated by heat, so the cut end does not open up before binding.
3. 1.5-5 m length range: short heavy leads rather than long runs, with winding spacing 80-120 mm.
4. Figure-8 single tie, head and tail on the same side, 130-150 mm retained on each end.
5. 800 pcs/h at 1.8 m, rated on the most common length for this wire size.
6. Single-phase 220 V supply at 2800 W, 0.5-0.65 MPa air, 1060 x 800 x 1600 mm, about 230 kg.
Technical Specifications
| Parameter | Specification |
|---|
| Model Number | WPM-81ML |
|---|
| Applicable Wire Diameter | 4 mm |
|---|
| Cutting Line Length | 1.5-5 m |
|---|
| Winding Tie Shape | Figure-8 single tie, head and tail on the same side |
|---|
| Winding Spacing | 80-120 mm |
|---|
| Tie Diameter | ≤40 mm |
|---|
| Head and Tail Length | 130-150 mm |
|---|
| Production Efficiency | ≤800 pcs/h (1.8 m) |
|---|
| Applicable Binding Tape | Coated iron core ≤5 kg/roll |
|---|
| Applicable Pressure | 0.5-0.65 MPa |
|---|
| Power Supply | 220 V / 50 Hz |
|---|
| Machine Power | 2800 W |
|---|
| Machine Weight | about 230 kg |
|---|
| Machine Size | 1060 L x 800 W x 1600 H mm |
|---|
Applications
— Appliance power cords: 4 mm jacketed leads of 1.5-5 m, coiled with both ends on the same side for carton packing.
— Power tool leads: heavy flexible cords cut and thermally finished before strain relief fitting.
— Industrial equipment supply cords: short leads for control cabinets and machine inlets.
— Stage and lighting power leads: 2-5 m cords coiled and tied for rental stock.
— Pump and heater leads: thick-jacket cords where an open, frayed cut end is not acceptable.