The WPM-141 is a bench-top semi-automatic soldering machine for one joint at a time: a wire or cable conductor into a terminal, a connector pin or a lug. The head is pneumatic, the solder is fed as wire, and the iron works at a fixed 90 degrees. Output is 800-1200 pcs/h from a 280 W machine on AC220V/110V at 0.5-0.8 MPa, with a footprint of 810 x 510 x 460 mm.
Hand soldering depends on three things the operator cannot hold constant: tip angle, dwell time and the amount of solder on the joint. Here the iron is carried on a slide with a pneumatic stroke, so the approach angle and depth are set by the fixture. The solder wire is driven by a motor at the top of the column in a set length per cycle, and the foot pedal starts the cycle, leaving both hands on the work. A flexible-duct fan is aimed at the joint to set the solder before the part is lifted, which is the step that usually distorts a hand-soldered terminal.
Against the WPM-121-AM, the 141 is the universal machine: it accepts any fixture built for it and is loaded by hand at 800-1200 pcs/h, while the 121-AM is dedicated to USB A male plugs with automatic feeding at 1000-1400 pcs/h. Against the WPM-904, the 141 is a contact iron with solder wire; the 904 heats the joint by high frequency in 0.3-0.6 s without a tip touching the work.
Key Features
1. 800-1200 pcs/h, roughly 3.0-4.5 s per joint including load and unload.
2. 280 W iron held at constant temperature, with the tip angle fixed at 90 degrees by the head mount.
3. Motor-driven solder wire feeder on the column, metering a set wire length per cycle instead of feeding by hand.
4. Pneumatic head stroke at 0.5-0.8 MPa air, giving the same travel and contact pressure on every cycle.
5. Foot-pedal actuation: the cycle starts with the foot, so both hands stay on the wire and the connector.
6. Flexible-duct cooling fan aimed at the joint, so the solder sets before the part leaves the fixture.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-141 |
|---|
| Machine type | Semi-automatic soldering machine |
|---|
| Voltage | AC220V/110V |
|---|
| Power | 280W |
|---|
| Air pressure | 0.5-0.8 MPa |
|---|
| Productivity | 800-1200 pcs/h |
|---|
| Soldering angle | 90 degree |
|---|
| Soldering material | Soldering wire |
|---|
| Temp control model | Constant temperature |
|---|
| Dimension | 810*510*460 mm (L*W*H) |
|---|
Applications
— Wire-to-terminal joints in wire harness sub-assembly, one conductor into a brass or tinned terminal.
— Connector pigtails: soldering conductor ends into plug shells before overmoulding or assembly.
— Home appliance internal wiring, including thermostat, switch and motor lead joints.
— Sensor and solenoid leads, where the joint has to be repeatable rather than fast.
— Audio, video and power cable connector soldering in small and medium batches.