The WPM-02 is a compact wire prefeeder that pays wire off a spool into a cut-and-strip line. A spool of up to 14 kg sits on a centering spindle inside a rotating dish, driven by a 0.1 kW motor on AC 220 V 50 Hz. The unit weighs 8.8 kg and is carried between benches by hand.
The dish turns with the spool, so wire leaves the coil without being dragged off the side, and the pull on the cutter's feed rollers stays close to zero. That removes the two faults of feeding from a static spool: the wire tightening on the barrel and snapping short at the blade, and the coil collapsing into loose loops when the machine stops. The dish lip contains the coil as it unwinds. Any electric wire can be run except flat and ribbon cable.
This is the smallest pay-off unit in the range. The WPM-F003 is a floor frame with a 750 W motor and 50 kg capacity, the WPM-C002 carries 20 kg through two motors and ten speed levels, and the WPM-E001 and WPM-E005 feed four and five reels at once. The WPM-02 is the unit for a single small spool on a bench.
Key Features
1. 14 kg spool capacity on a rotating dish with a centering spindle, driving wire off the coil rather than pulling it from a static barrel.
2. 0.1 kW motor on AC 220 V 50 Hz, sized to hold a light loop without overrunning a small spool.
3. 8.8 kg net weight, moved by hand between benches without a trolley.
4. Front-panel speed dial and power switch, with the dish recessed into the housing for a low bench height.
5. Runs all electric wires except flat and ribbon cable, covering hook-up wire through small power cable.
6. Dish lip contains the coil during unwind, which stops the spool from spilling when it nears the core.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-02 |
|---|
| Machine type | Compact wire prefeeder / pay-off unit |
|---|
| Loading capacity | ≤14 kg |
|---|
| Rated power | 0.1 kW |
|---|
| Voltage | AC 220 V, 50 Hz |
|---|
| Suitable wires | All electric wires except flat cables |
|---|
| Spool position | Vertical, on rotating dish with centering spindle |
|---|
| Net weight | 8.8 kg |
|---|
Applications
— Bench-top pay-off ahead of a cut-and-strip machine running spools up to 14 kg
— Short-run and sample harness cells where wire changes several times per shift
— Appliance cord set production: feeding insulated single wire into a cutting head
— Rewinding wire from bulk reels into smaller working spools
— Panel shop wiring stock: paying off hook-up wire to a manual cutting station