WPM-006S runs cutting, stripping, twist tinning, crimping and heat shrink tube insertion in one sequence. One end is twisted and tinned, the other receives a crimped terminal, and a heat shrink tube is slipped over the crimp before the lead is discharged.
Twisting, tinning, crimping and tube placement are normally four separate operations with handling between each. Here the lead stays in the same transport clamp from the cutter to the discharge, so it is handled once and the tube is fitted by the machine rather than at the assembly bench.
The platform is shared with the wpm-068: the same AWG24-AWG12 range, the same 75-9999mm cut length and the same 1800-2200 pcs/h, with a twist tinning station added. Where the joint is sealed with a rubber water seal instead of heat shrink tube, the WPM-078H is the matching model.
Key Features
1. Five-process cycle: cutting, stripping, twist tinning, crimping and heat shrink tube insertion.
2. Twist tinning station prepares the free end for soldering without a separate solder pot.
3. Heat shrink tube is inserted over the crimp within the same cycle.
4. Wire range AWG24-AWG12; capacity 1800-2200 pcs/h.
5. 2.0T press, stripping length 0-8mm, cut length 75-9999mm.
6. 5-6 kgf air supply; frame 1800 x 800 x 1860mm, approximately 600kg.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-006S |
|---|
| Power | AC220V / 50-60Hz |
|---|
| Capacity | 1800-2200 pcs/h |
|---|
| Functions | Cut, strip, twist tin, crimp, heat shrink tube insertion |
|---|
| Wire Range | AWG24 - AWG12 |
|---|
| Cutting Length | 75-9999mm (customizable) |
|---|
| Cutting Accuracy | 0.5mm + cutting length x 0.2% |
|---|
| Stripping Length | 0-8mm |
|---|
| Crimping Force | 2.0T |
|---|
| Air Pressure | 5-6 kgf |
|---|
| Dimensions | 1800 x 800 x 1860mm |
|---|
| Weight | approximately 600kg |
|---|
Applications
— Appliance leads with one tinned end for a PCB or terminal block and one crimped terminal under heat shrink tube.
— Lighting and transformer harnesses: tinned strand end plus a crimped connector with sleeve.
— Automotive sub-harnesses: tinned end for splicing, crimped terminal with sealed tube at the other end.
— Power supply output leads: AWG16-AWG12 wire, tinned and crimped ends in one run.
— Motor leads: tinned end for the terminal block, crimped ring terminal with heat shrink.