Desktop Heat Shrink Tube Machine for Wire Harness, 2000pcs/h WPM-H550
Desktop Heat Shrink Tube Machine for Wire Harness, 2000pcs/h WPM-H550 Thumb
Video Thumbnail

Desktop Heat Shrink Tube Machine for Wire Harness, 2000pcs/h WPM-H550

📅 2026-03-16 👁️ 2,652
  • Model No: WPM-H550

  • Specifications

    Working Voltage: AC220V±10%, 50Hz
    Applicable Tube Size: OD < 10mm, length < 60mm (customizable)
    Applicable Wire Size: OD < 10mm, cable length > 195mm (customizable)
    Heating Method: Ceramic heating panel
    Heater Power: 1000W*2
    Working Efficiency: 2000 pcs/h
    Temperature Setting: 0~600℃
    Machine Dimensions: 1100mm x 225mm x 350mm
    Machine Weight: 40kg
  • Inquiry now

The WPM-H550 is a desktop heat shrink tube machine that shrinks tube onto wire harness ends with ceramic heating panels above and below the workpiece. It processes up to 2000 pieces per hour, with the temperature set anywhere from 0 to 600°C on the panel. It is sized for harness shops and panel builders that shrink tube in batches and want a bench unit rather than an inline tunnel.

Key Features

  • Up-and-down heating — ceramic panels heat from both sides at once, so the tube shrinks evenly around the splice instead of drawing to one face.
  • Stable shrink temperature — the setpoint holds through the cycle, which protects the wire insulation while still fully activating the tube.
  • 2000 pieces per hour — output depends on tube material and cable type, but the cycle is short enough for small and medium batch work.
  • Low power draw — two 1000 W ceramic heaters reach working temperature quickly and draw nothing like a tunnel oven.
  • Desktop footprint — at 1100 × 225 × 350 mm and 40 kg the unit sits on a bench beside the assembly station.
  • Simple to operate — the operator places the harness and starts the cycle; there is no tooling change between tube sizes within the working height.
  • Complete shrinkage — sustained heat activates the tube fully, which is where the seal quality on the finished harness actually comes from.

Technical Specifications

ModelWPM-H550
Working voltageAC220V ±10%, 50Hz
Heating methodCeramic heating panel
Heater power1000 W × 2
Working efficiency2000 pcs/h (material and cable dependent)
Temperature setting0–600°C
Dimensions1100 × 225 × 350 mm
Weight40 kg

Applications

  • Heat shrink tube on wire harness splices and terminals
  • Automotive and appliance harness assembly
  • Control panel and equipment wiring
  • Low-voltage cable end sealing

Why Choose This Model

Two-sided ceramic heating is the reason the H550 holds a steady shrink without scorching the insulation, which is the usual failure on hot-air hand tools. The unit runs from a single-phase 220V outlet and needs no compressed air, so it can be placed wherever the harness bench is. Standard machines ship with a spare heater set, and the working height can be customized for longer assemblies. Compared with a tunnel oven, only the part in the heating zone is powered, which is where the energy saving shows up on the electricity bill.

Heat Shrink Tube Machine WPM-H550

Send us your question about this product

No file chosen
JPG / PNG / WebP, up to 10 MB each