The WPM-20M is a bench-top pneumatic crimping machine for non-insulated terminals on stripped wire ends. A 2.5T pneumatic cylinder closes the die in a single downward stroke, so ring lugs, fork terminals, butt splices and tab connectors are formed to the same crimp height on every cycle instead of depending on how hard the operator squeezes.
Manual crimping of larger terminals depends on hand force, and output falls as the operator tires. The WPM-20M is driven by 0.5–0.8MPa shop air through a regulator, so the closing force is set once and repeated. The die block sits in an open throat at the front of the 275×128×145mm frame, leaving both hands free to place the terminal and hold the wire. At 5.5kg the unit is carried by its top handle between benches and connected to the air line at the side inlet.
In the WPM pneumatic range the 20M is the compact 2.5T model with a bolted die block and an open front throat, intended for bare terminals. The WPM-50L shares the 2.5T output and the 275×128×145mm envelope but seats its die in a swing-latch holder for quicker changes. The WPM-120Y covers a stated 0.25–120mm² range on a 286×125×165mm frame at 0.5–0.7MPa, and the WPM-300L moves to 9.0T for heavy lugs.
Key Features
1. 2.5T pneumatic output, set by the air regulator, closes the die fully in one stroke on every terminal rather than relying on operator hand force.
2. Runs on 0.5–0.8MPa shop air and connects at the side inlet, so the machine ties into an existing compressed-air drop at the bench.
3. Open crimping throat at the front of the frame gives clear access to the die for ring lugs, fork terminals, butt splices and tab connectors.
4. Die block is bolted to the frame and can be exchanged for other terminal families without altering the machine.
5. 275×128×145mm housing and 5.5kg weight place the unit on a bench top beside a stripping station.
6. Folded top handle clears the cylinder and acts as a guard while the machine is carried between work stations.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-20M |
|---|
| Machine type | Pneumatic Terminal Crimping Machine |
|---|
| Output | 2.5T |
|---|
| Air Pressure Range | 0.5–0.8MPa |
|---|
| Overall Dimension | 275×128×145mm |
|---|
| Weight | 5.5kg |
|---|
| Crimping Dies | Interchangeable |
|---|
Applications
— Automotive and motorcycle harness lines, crimping non-insulated ring and fork terminals onto battery, earth and lighting cables before loom assembly.
— Control cabinet building, terminating stripped panel wire with ring and fork lugs ahead of connection to terminal blocks and earth bars.
— Appliance and motor lead production, where butt splices and tab terminals join lead ends inside the housing.
— Cable assembly houses running short batches of bespoke leads and changing die sets between terminal families.
— Maintenance workshops re-terminating damaged lugs on installed machinery and switchgear.