The WPM-25ZWJ cuts, strips and bends wire in one pass. It handles 1 to 25 mm2 PVC, silicone and glass fibre cable, cuts to any length from 1 mm to 9999 mm, strips 1 to 50 mm at the front end and 1 to 30 mm at the rear, and forms U, Z and clockwise bends at 30, 45, 60 or 90 degrees.
On a manual line the same lead passes through a cut-and-strip machine, then a separate bending jig, and the leg dimensions depend on how the wire is located in the jig. Here the wire is straightened by a roller straightener, fed by four rollers, cut and stripped by a tungsten steel blade, and bent by the head on the same machine that set the length, so the bent leg follows the programmed dimension. Cutting tolerance is 0.2 plus 0.002 times the length, and output at a 100 mm length is 2000 to 3000 pieces per hour.
The other machines in this group each do one operation: strip only, straighten only, or feed only. This model adds bending to cutting and stripping and goes up to 25 mm2, which is why it carries a 650 W drive and a 33 kg frame rather than a bench-top housing.
Key Features
1. Wire range 1 to 25 mm2, covering control wire through 25 mm2 power core in PVC, silicone and glass fibre insulation.
2. Cut length 1 to 9999 mm with a tolerance of 0.2 plus 0.002 times the length in mm.
3. Four bend forms in one program: U, Z, clockwise, and angles of 30, 45, 60 or 90 degrees.
4. Front strip 1 to 50 mm and rear strip 1 to 30 mm, so the two ends can be stripped to different lengths in the same cycle.
5. Output of 2000 to 3000 pieces per hour at a 100 mm cut length.
6. Hard tungsten steel blade, four-roller feed and a multi-roller straightener on the entry arm; 650 W on 220 V or 110 V, 400 x 515 x 345 mm, 33 kg.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-25ZWJ |
|---|
| Machine type | Automatic wire cutting, stripping and bending machine |
|---|
| Functions | Cutting, stripping, bending |
|---|
| Wire core section | 1 to 25 mm2 |
|---|
| Cutting length | 1 to 9999 mm |
|---|
| Stripping length | Front 1 to 50 mm; rear 1 to 30 mm |
|---|
| Bending shape | U, Z, clockwise; angle 30, 45, 60, 90 degrees |
|---|
| Cutting tolerance | (0.2 +/- 0.002 x L) mm |
|---|
| Output | 2000 to 3000 pcs/h at L = 100 mm |
|---|
| Blade material | Hard tungsten steel |
|---|
| Voltage / power | 220 V / 110 V, 650 W |
|---|
| Dimension | 400 x 515 x 345 mm |
|---|
| Weight | 33 kg |
|---|
Applications
— Switchgear and control panel wiring, producing bent jumpers between terminal blocks at fixed leg dimensions.
— EV and automotive harness, cutting, stripping and forming 25 mm2 power leads in one cycle.
— Appliance internal wiring, bending U and Z forms for door and hinge runs.
— Lighting and driver leads, where a 90 degree bend is needed at the board entry.
— Silicone and glass fibre cable for high-temperature appliances, cut and stripped without the insulation fraying.