WPM-078H cuts the wire, strips both ends and crimps one or both ends while a water seal is pushed onto the wire at the crimp position. Seals are fed from the vibratory bowl at the rear of the frame and inserted in the same cycle, so the lead leaves with the seal seated behind the terminal.
Water seals are small, orientation-sensitive parts normally fitted by hand after crimping, and a missing or reversed seal is only found at the leak test. Feeding them from the bowl removes that manual step and keeps the seal position consistent from lead to lead.
The range is 0.3-2.5 mm2 (AWG28-AWG14) with cut lengths from 45mm, the shortest minimum in this group, and output of 2000-3000 pcs/h at 150mm. One-side or both-side crimping can be selected; where the joint is covered with heat shrink tube instead of a water seal, the wpm-068 or WPM-006S is used.
Key Features
1. Cut, strip both ends, crimp and insert water seals in one cycle, with one-side or both-side crimping selectable.
2. Vibratory bowl feeds the seals to the insertion station, removing manual seal fitting.
3. Wire range 0.3-2.5 mm2, AWG28-AWG14.
4. Cut length 45-3000mm, the shortest minimum in the range; capacity 2000-3000 pcs/h at 150mm.
5. OTP, European and Korean applicators accepted; 30mm crimping stroke, 40mm optional.
6. Cutting accuracy 0.5mm + 0.2%; stripping length 0.5-8mm; 5-6 kgf air supply.
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-078H |
|---|
| Power | AC220V / 50-60Hz |
|---|
| Wire Range | 0.3-2.5 mm2, AWG28 - AWG14 |
|---|
| Functions | Cut, both-end strip, one-side/both-side crimp, water seal insertion |
|---|
| Cutting Length | 45-3000mm (customizable) |
|---|
| Cutting Accuracy | 0.5mm + cutting length x 0.2% |
|---|
| Stripping Length | 0.5-8mm (customizable) |
|---|
| Capacity | 2000-3000 pcs/h (L=150mm) |
|---|
| Crimping Stroke | 30mm (40mm optional) |
|---|
| Applicator | OTP, European, Korean |
|---|
| Air Pressure | 5-6 kgf |
|---|
Applications
— Automotive waterproof harnesses: 0.5-2.5 mm2 wire with insulated terminals and rubber water seals.
— Outdoor lighting and pump leads with sealed crimp joints.
— Marine and agricultural equipment harnesses using water seal connectors.
— Appliance leads for damp or washdown areas, with sealed ring and fork terminals.
— Sensor leads requiring a single-wire seal at one or both ends.