The WPM-189 cuts, strips and crimps three terminal ends in one cycle. Wire is cut between 45 mm and 3200 mm, the head end stripped to 10 mm and the tail end to 14 mm, and three ends are pressed at 2 to 3 T, giving 3500 to 4000 pcs/h on AWG16 to AWG28.
A three-end lead normally travels through three crimping operations with two handling steps in between, and the branch position is measured by hand at each one. The WPM-189 indexes the wire through all three stations inside one cycle, so branch position, strip depth and crimp height repeat without re-clamping. Detection for terminal presence, wire presence and insufficient crimping pressure rejects an incomplete lead at the machine instead of at bundle assembly.
It is the only triple-end model here. Output of 3500 to 4000 pcs/h is lower than the 4800 pcs/h of the double-end JW-CM09, but each cycle carries three crimped ends; the 3200 mm maximum cutting length is shorter than the 9999 mm of the single- and double-end models, which matches its use on short branched leads rather than long runs.
Key Features
1. Three terminal ends crimped in one cycle from a single wire feed
2. Wire range AWG16 to AWG28; cutting 45 - 3200 mm at length x 0.2 percent accuracy
3. Head-end strip 10 mm and tail-end strip 14 mm, set per station
4. Output 3500 - 4000 pcs/h with three crimped ends per cycle
5. Detection for terminal presence, wire presence and insufficient crimping pressure
6. Pressing capacity 2 - 3 T, 0.5 MPa air, AC220 V 50 Hz; 750 x 800 x 1700 mm, 400 kg
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-189 |
|---|
| Function | Cutting, stripping, triple-end terminal crimping |
|---|
| Wire Range | AWG16 - AWG28 |
|---|
| Cutting Length | 45 - 3200 mm |
|---|
| Cutting Accuracy | Cutting length x 0.2% |
|---|
| Stripping Length | Head 10 mm / tail 14 mm |
|---|
| Pressing Capacity | 2 - 3 T |
|---|
| Output | 3500 - 4000 pcs/h |
|---|
| Detection Device | Terminal, wire, insufficient pressure |
|---|
| Air Pressure | 0.5 MPa |
|---|
| Power Supply | AC220 V / 50 Hz |
|---|
| Dimensions | 750 x 800 x 1700 mm |
|---|
| Weight | 400 kg |
|---|
Applications
— Branched appliance harnesses: AWG18 to AWG22 with three reel-fed terminals on one lead
— Y-leads and split power cords: AWG16 to AWG20 with ring terminals
— Control and signal branches: AWG22 to AWG28 with small reel terminals
— Automotive auxiliary looms that require a mid-run branch termination
— Lighting distribution leads with one feed and two outgoing ends