WPM-2P_64P is a pneumatic crimping machine for IDC flat ribbon cable connectors, covering 2P to 64P. A single air cylinder drives the ram at 6 to 8 kg supply pressure, and output runs 300 to 600 crimps per hour. The unit is a bench machine of 250 x 200 x 330 mm and 14 kg, on 110 V or 220 V, 50/60 Hz.
Ribbon connectors are usually closed with a hand plier or an arbor press, where the result depends on how hard the operator squeezes and how squarely the connector sits on the cable. Here the cylinder supplies a repeatable stroke and the connector is nested in a machined fixture, so every position along the cable closes to the same depth. Three fixture sets cover the range: 4 to 30P, 30 to 50P and 64P.
This is the only pneumatic IDC machine in the group. The WPM-FCCM-18 covers 2P to 20P with adjustable crimp direction; the WPM-2P_64P reaches 64P and relies on fixed fixtures per pitch instead. The EM-6B1 and EM-6B2 are electric and handle insulated terminals up to 10 mm2, not ribbon connectors, so the two families do not overlap.
Key Features
1. Pneumatic ram on 6 to 8 kg air supply, giving a repeatable closure depth that does not depend on operator force
2. 2P to 64P coverage from three fixture sets: 4 to 30P, 30 to 50P and 64P, changed as complete nests
3. 300 to 600 crimps per hour, with each connector closed in a single controlled stroke
4. Fixtures are machined blocks that locate the connector body and hold the cable flat, so the pitch is set by the nest rather than by eye
5. Air does the working stroke; 110/220 V 50/60 Hz is needed only for the control circuit, so there is no motor or flywheel running between cycles and the 14 kg frame can be moved between benches
6. The ram runs inside the aluminium housing and the cable is held in the fixture, which keeps hands behind the die line during closure
Technical Specifications
| Parameter | Specification |
|---|
| Model | WPM-2P_64P |
|---|
| Machine type | Pneumatic IDC flat ribbon cable crimping machine |
|---|
| Crimping capacity | 2P to 64P |
|---|
| Crimping speed | 300 - 600 crimps per hour |
|---|
| Air supply | 6 - 8 kg |
|---|
| Voltage | 110/220 V, 50/60 Hz |
|---|
| Fixture configuration | 4-30P one fixture, 30-50P one fixture, 64P one fixture |
|---|
| Dimensions | 250 x 200 x 330 mm |
|---|
| Weight | 14 kg |
|---|
Applications
— Computer and AV ribbon assemblies: 2P to 64P IDC connectors closed onto flat cable
— Appliance internal flat cable: display and keypad ribbons terminated at the bench
— Control board to panel links: ribbon runs cut to length and crimped on both ends
— Test and instrument cable: low-volume ribbon sets where a plier gives inconsistent depth
— High-pin work up to 64P: the third fixture set covers connectors that hand tools cannot close evenly