Half-Stripped Wire Twisting Machine for Multi-Core Cables WPM-3T
Half-Stripped Wire Twisting Machine for Multi-Core Cables WPM-3T Thumb
Video Thumbnail

Half-Stripped Wire Twisting Machine for Multi-Core Cables WPM-3T

📅 2026-03-06 👁️ 2,398
  • Model No: WPM-3T

  • Specifications

    Model: WPM-3T
    Application: Twisting multi-core cables
    Process Requirement: Half-stripped cables
    Capacity: 2-5 cables simultaneously
    Torque: Large torque
    Compatible Machine: WPM-3F stripping machine
    Service Life: Long service life
  • Inquiry now

The WPM-3T is a bench twisting unit for half-stripped multicore cable. It takes the exposed ends left by a stripping machine and twists 2 to 5 of them in one cycle, driven by a geared motor on a cast base. It is specified with the WPM-3F stripper, which produces the half-stripped end the 3T requires.

Hand twisting a bundle of two to five cores gives a different lay every time and leaves stray strands at the insulation shoulder. The 3T lays the exposed ends into the radial grooves of a ribbed disc chuck mounted on the gear motor shaft; the disc turns and draws all the ends into one spiral at the same time, and the large torque of the geared drive holds the twist on a full five-core bundle without stalling. Because the cable is only half-stripped, the insulation behind the twist stays intact and acts as the stop.

It is not a stripping machine. The WPM-180 and WPM-200T strip and twist in one unit over 2 to 20 mm and 3 to 45 mm respectively, and the WPM-003A and WPM-03B twist a single shield tail over 5 to 60 mm and 10 to 80 mm. The 3T works on the whole conductor bundle at once, 2 to 5 cores per cycle, and takes its half-stripped input from the WPM-3F.

Key Features

1. Twists 2 to 5 conductors in one cycle; the capacity is the disc chuck, not a per-wire pass.

2. Geared motor with large torque drives the ribbed disc directly, so a five-core bundle is pulled into the twist without stalling.

3. Accepts half-stripped cable only, so the insulation shoulder sets the twist start and no twist length has to be programmed.

4. Runs in line with the WPM-3F stripping machine, making strip and twist two stations on the same harness bench.

5. The ribbed disc holds each conductor end in its own radial groove, so the bundle enters the twist evenly.

6. Cast base with four mounting holes and a toggle switch on the column; the unit bolts to a bench and needs no air supply.

Technical Specifications

ParameterSpecification
ModelWPM-3T
Machine typeBench twisting machine for half-stripped multicore cable
ApplicationTwisting multi-core cables
Process requirementHalf-stripped cables
Capacity2-5 cables simultaneously
TorqueLarge torque
DriveGeared motor with ribbed disc chuck
Compatible machineWPM-3F stripping machine
Service lifeLong service life

Applications

— Multicore control cable: 2-5 half-stripped cores twisted before ferrule fitting.

— Building wiring harness: twisted pairs and triples at the panel end.

— Sensor cable with 3 or 4 cores: uniform twist ahead of connector assembly.

— Power cord with two or three cores: twist at the plug end after half-stripping.

— Electronic cable: cores twisted into one bundle before soldering to a board.

Half Strip Wire Twisting Machine WPM-3T
Half Strip Wire Twisting Machine WPM-3T

Send us your question about this product

No file chosen
JPG / PNG / WebP, up to 10 MB each